Mudhugger Gravel Rear Fender - Steed Cycles
Mudhugger Gravel Rear Fender - Steed Cycles

Mudhugger Gravel Rear Fender

Regular price$49.99 CAD
/

New for 2020, the Rear GravelHugger.

Following the tried and tested rear Mudhugger design, will fit most bike frame seat stays (with angles approx 40-55 degrees) and designed for tyres up to 50mm wide.

The Rear GravelHugger is designed to be attached to the bike with zipties as these afford the most secure way to fitting. See fitting vid below, fitting the new GH is the same as our tried and tested MTB Rear Mudhugger :)

Helitape is supplied to protect the seat stays where the GravelHugger sits on the seat stays, ensure you use this tape, invisframe, electrical tape or similar are not sufficiently thick to protect your bikes paint and frame.

Suitable for 700c and 650b wheels Max tyre width 50mm (depending on wheel/tyre combination).

Weight approx 150g - Length 560mm -Width 55mm

Designed, made and packed in the UK from 99% recycled polypropylene, which of course can be recycled again.

***PLEASE NOTE***

Please ensure to regularly check the tightness of the zipties and the condition of the helitape, the tape will wear out over time. Failure to do so could result in permanent damage to your bikes paint and frame. Replace any loose zipties or worn helitape, both of which are available to buy from our website.

SKU: REARgravelHUGGER

This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.


Recently viewed